Regency E33S-NG1 Sunrise Owners & Installation Manual page 20

E33S
installation
6) Remove the left and right side inner panels by removing the clip that
holds the panels in place. Left side panel clip shown.
Note: Screw does not need to be completely removed, only loosened.
7) Remove the back panel by lifting up and slide out carefully.
Note: The removed standard panels may be discarded.
Installation of Black Enamel or Stainless Steel Panels
8) Loosen the 2 end screws + 1 centre screw securing the heat defl ector.
Slide the top refl ective panel in place over top of the heat defl ector.
9) Secure top panel using 2 screws at the back - then tighten the 3
screws at the front
20
918-878
10) After the top panel has been secured - install the back panel. The
back panel is held in place by the side panels
11) Install the left side panel - secure in place one screw and a panel
clip.
:
2
12/21/09
Regency E33S-1 Sunrise Gas Insert
®