Maintenance; Maintenance Instructions; General Vent Maintenance; Door Glass - Regency E33S-NG1 Sunrise Owners & Installation Manual

MAINTENANcE

MAINTENANcE
INSTRUcTIONS
1) Always turn the gas valve to the off position
before cleaning. For relighting, refer to
lighting instructions. Keep the burner and
control compartment clean by brushing and
vacuuming at least once a year.
2) Clean (never when unit is hot) appliance,
door and louvers with a damp cloth. Never
use an abrasive cleaner. The optional
finishes on louvers and doors may be
scratched if abrasives are used to clean
them. The heater is finished in a heat
resistant paint and should only be refinished
with heat resistant paint (not with wall paint).
FPI uses StoveBrite Paint - Metallic Black
#6309.
3) Make a periodic check of the burner for
proper position and condition. Visually
check the flame of the burner periodically,
making sure the flames are steady: not
lifting or floating. If there is a problem, call
a qualified service person.
4) The appliance and venting system must be
inspected before use, and at least annually,
by a qualified field service person, to ensure
that the flow of combustion and ventilation
air is not obstructed.
During the annual service call, the burners
should be removed and cleaned from the
burner tray.
5) Keep the area near the appliance clear and
free from combustible materials, gasoline
and other flammable vapours and liquids.
WARNING: cHIlDREN AND
ADUlTS SHOUlD BE AlERTED
TO THE HAZARDS OF HIGH
SURFAcE TEMpERATURE AND
SHOUlD STAY AWAY TO AVOID
BURNS OR clOTHING IGNITION.
YOUNG cHIlDREN SHOUlD
BE cAREFUllY SUpERVISED
WHEN THEY ARE IN THE SAME
ROOM AS THE ApplIANcE.
cAUTION: ANY SAFETY ScREEN
OR GUARD REMOVED FOR
SERVIcING AN ApplIANcE
MUST BE REplAcED pRIOR TO
OpERATING THE ApplIANcE.
c l O T H I N G O R
FlAMMABlE MATERIAl SHOUlD
NOT BE plAcED ON OR NEAR
THE ApplIANcE.
31
Regency E33S-1 Sunrise Gas Insert
®
6) Each time the appliance is lit, it may cause
condensation and fog the glass.
condensation and fog is normal and will
disappear in a few minutes as the glass
heats up.
Never operate the appliance without the
glass properly secured in place or with
the door open.
7) Do not use this appliance if any part has been
under water. Immediately call a qualified
service technician to inspect the appliance
and to replace nay part of the control system
and any gas control which has been under
water.
8) Periodically check the pilot flames. Correct
flame pattern has three strong blue flames: 1
flowing around the thermopile and 1 around
the thermocouple, and 1 flowing across the
front of the burner.
Note: If you have an incorrect flame pattern,
contact your FpI dealer for further
instructions.
Incorrect flame pattern will have small, probably
yellow flames, not coming into proper contact
with the rear of the burner or thermopile.
Top View of pilot flame
GENERAl VENT
MAINTENANcE
Conduct an inspection of the venting system
O T H E R
semi-annually. Recommended areas to inspect
as follows:
1) Check the Venting System for corrosion in
areas that are exposed to the elements.
These will appear as rust spots or
This
Burner
Burner
MAINTENANcE
streaks, and in extreme cases, holes.
These components should be replaced
immediately.
2) Remove the Termination Cap, and shine a
flashlight down the Vent. Remove any bird
nests, or other foreign material.
3) Check for evidences of excessive
condensation, such as water droplets forming
in the inner liner, and subsequently dripping
out the joints. Continuous condensation can
cause corrosion of caps, pipe, and fittings.
It may be caused by having excessive
lateral runs, too many elbows, and exterior
portions of the system being exposed to cold
weather.
4) Inspect joints to verify that no pipe
sections or fittings have been disturbed,
and consequently loosened. Also check
mechanical supports such as Wall Straps,
or plumbers' tape for rigidity.

DOOR GlASS

If your glass requires cleaning, we recommend
using an approved glass cleaner available at
all authorized dealers. Do not use abrasive
materials. Do not clean the glass when hot.
In the event that you break your glass by
impact, purchase your replacement from an
authorized FPI dealer only, do not use substitute
materials. Follow our step-by-step instructions
for replacement. Warning: Wear gloves when
removing damaged or broken glass.
caution: Do not operate appliance with glass
removed, cracked or broken. Replacement
of the glass should be done by a licensed
or qualified service person.
Glass Replacement
Remove the glass door (refer to the "Glass
Door" Installation section). Remove the 4
glass clips from each corner. Slide in the new
replacement glass. Push the 4 glass clips back
onto the frame.
Regency E33S-1 Sunrise Gas Insert
®
31