Page 2
TRD Beholder MS1 Camera Stabilizer ® Specifications: Maximum Supported Camera Weight 850 g / 1.9 lb. Height: 268 mm / 10.5 in. Supported Camera Models: Sony A7S, Length: 168 mm / 6.6 in. NEX series, Panasonic DMC, GH4, BMPCC, RX100, A6000, Canon G7, A7ii, Width: 123 mm / 8 in.
The Beholder MS1 Camera Stabilizer is designed to support professional videographers of all levels. The stabilizer is easy to use and small enough to travel with. The Beholder MS1 Stabilizer is intuitive and offers a greater range of camera movement. 2. Battery Setup and Charging A.
C. Adjust the left-right balance of the camera. Small adjustments maybe needed. D. Adjust the front and rear balance. Once gimbal is balanced, tighten the quick release lock. If the camera does not balance perfectly, don’t worry; the MS1 will usually be able to maintain stability.
To calibrate the gyro, press and hold the joystick for 3 seconds. The gyro controls the horizontal level. During calibration the MS1 must not be touched and the gimbal must be level. Page 4...
Red light means low battery. Flashing red light means batteries need to be charged. Note: the MS1 will shut down to protect the batteries. 5. Other Features A. The stabilizer can be mounted to a tripod, selfie stick, and more.
Page 7
The following angles are not possible. 8. Attention A. If the stabilizer needs to be calibrated, place the MS1 on a flat surface. Make sure the camera is balanced on the gimbal. Press and hold the joystick button for 3 seconds.