Ikan MS1 Quick Start Manual

Ikan MS1 Quick Start Manual

Beholder gimbal for mirrorless cameras
Hide thumbs Also See for MS1:

Advertisement

Quick Links

MS1
Beholder Gimbal for Mirrorless Cameras
What's Included
1 x Stabilizer
1 x Battery Holder
1 x Battery Cap
1 x Quick Release Plate
1 x USB LED Light
1 x Adapter Plate
1 x Micro USB Cable
2 x ¼"-20 Screw
3 x 18650 Batteries
www.ikancorp.com
support@ikancorp.com
QUICKSTART GUIDE
© 2016 ikan Corporation. All rights Reserved
CHECKED BY
713.272.8822

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MS1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Ikan MS1

  • Page 1 1 x Battery Cap 1 x Quick Release Plate 1 x USB LED Light CHECKED BY 1 x Adapter Plate 1 x Micro USB Cable 2 x ¼”-20 Screw 3 x 18650 Batteries www.ikancorp.com 713.272.8822 support@ikancorp.com © 2016 ikan Corporation. All rights Reserved...
  • Page 2 Beholder MS1 Camera Stabilizer Specifications Height: 268mm, 10.5 Inches Max Supported Camera Weight: 850g, 1.9 lbs Length: 168mm, 6.6 Inches Supported Camera Models: Sony A7S, NEW Series, Panasonic DMC, GH4, BMPCC, RX100, Width: 123 mm, 4.8 Inches A6000, Canon G7, A7ii, and more.
  • Page 3 2. Battery Setup and Charging and Green lightsmeans almost fully charged. The stabilizer is easy to use and small enough to travel with. The Beholder MS1 Stabilizer is intuitive and d. Warning using a charger that does not support 1 offers a greater range of camera movement.
  • Page 4 D.Adjust the front and rear balance. Once gimbal is balanced, tighten the quick camera does not balance perfectly, don’t worry, the MS1 will usually be able to maintain stability. release lock. If the camera does not balance perfectly, don’t worry the MS1 will usually be able to maintain stability.
  • Page 5 E.Installation for small cameras. E.Installation for small cameras. Camera less than 400g such as Sony NEX5R and BMPCC will need an adapter Camera less than 400g such as Sony NEX5R and BMPCC will ne Installation for Small Cameras plate.The adapter plate will allow cameras that cannot mount properly to be mounted plate.The adapter plate will allow cameras that cannot mount pro on the gimbal.
  • Page 6 Press again to change to Follow Mode which will make the stabilizer fol horizontal level. During calibration, the MS1 must not be touched and the gimbal must be level on c. Press and hold the joystick for 3 seconds to calibrate the gyro.The the pan and tilt of your hand.
  • Page 7: Supported Cameras

    Other Features A. The stabilizer can be mounted to a tripod, selfie stick, and more A. The stabilizer can be mounted to a tripod, selfie stick, and more. B. LED USB light is great for shooting at night. B. Charge a cellpone from stabilizer. NOTE: Stabilizer must be OFF. USB Cable not included. A.
  • Page 8 (*Even if the product is still within the warranty period.) • Damage caused by abuse or misuse, dismantling, or changes to the product not made by the company. • Damage caused by natural disaster, abnormal voltage, and environmental factors, etc. ©2016 ikan Corporation. All rights reserved...

Table of Contents