4. How to Use
A. To start the stabilizer: with the camera and gimbal level, place on a flat surface at
90 degrees, and then press the power button.
Note: Starting the stabilizer in a position other than 90 degrees will result in
performance issues.
The correct way to start
B. Joystick mode selection
a. Press once for Lock Mode, which mode makes the stabilizer hold a position.
b. Press again to change to Follow Mode, which makes the stabilizer follow the
pan and tilt of your hand.
c. To calibrate the gyro, press and hold the joystick for 3 seconds. The gyro
controls the horizontal level. During calibration the MS1 must not be touched
and the gimbal must be level.
The wrong way to start
Page 4