Stihl TSA 230 Instruction Manual page 74

English
Always remove the battery from the machine before starting any work on the machine.
Fault
Machine switches off in operation
Running time is too short
Battery gets stuck during insertion in the
machine/charger
Battery does not charge although the LEDs
on the charger are green
LED on charger flashes red
1)
STIHL recommends STIHL servicing dealers
72
Cause
Battery or machine electronics too hot
Electrical or electromagnetic malfunction Remove battery and reinsert it
Battery is not completely charged
Service life of battery has been reached
or exceeded
Guides dirty
Battery too hot / too cold
(1 LED on battery is red)
No electrical contact between charger
and battery
Battery fault
(4 LEDs on battery flash red for
approx. 5 seconds)
Fault in charger
Remedy
Remove battery from the machine, let
battery and machine cool off
Charge battery
1)
Check battery and replace
Carefully clean guides
Let the battery cool down / let the battery
warm up gradually at temperatures of
approx. 15 °C - 20 °C (59 °F - 68 °F)
Operate the charger only in a closed, dry
space at ambient temperatures of +5 °C
bis +40 °C (41 °F - 104 °F)
Remove battery and reinsert it
Remove the battery from the machine
and reinsert it. Turn on the machine – if
the LEDs still flash, the battery is mal -
functioning and must be replaced
Have charger checked by a servicing
1)
dealer
TSA 230