Advertisement
MICROWAVE COOKING CENTER: CARE AND CLEANING
b.
Raise the unit coil, at point opposite recep-
tacle, aboutone inch abovethe pan/ring and pull
it away from the receptacle.
c. Carefully pull the unit terminalsthrough the
opening in the reflector pan/ring.
After removing the Plug-In surface unit, re-
move the chrome-plated reflector pan/ring to
clean under the unit.
NOTE: Ranges with Plug-In surface units have chrome-
plated reflector pan/rings.
DO NOT COVER WITH ALUMINUM FOIL. Clean as rec-
ommended in Cleaning Chart.
Wipe around edges of the surface unit opening
in the cooktop, clean the bowl-shaped area be-
low the unit and rinsewith damp cloth or sponge.
To
FBepkace
IwJg"hl
unit
a. Place chrome-plated reflector an/ring into
J
the unit recess in the cooktop so
e unit recep-
tacle can be seen through opening in reflector
pan.
b. Insert the terminalsof Plug-In unit through
opening in chrome-plated pan/ring and into
receptacle. s
c. Guide the surface unit into place so it fits
evenly.
Caution in Caring for
Plug-in Surface Units
DO NOT immerse Plug-In surface units in
liquid of any kind. See the Cleaning Chart
for cleaningof surfaceunit coils. If the spider
or medallionare cleaned, be certain to wipe
all cleaning materials thoroughly from the
unit coils before returning the unit to the
range.
DO NOT attempt to clean Plug-In surface
units in an automatic dishwasher or self-
cleaning oven.
DO NOT let the two electrical ends of the
Plug-In surface unit get damaged or bent.
The terminals are sturdy and will not be
damaged if handled with reasonable care.
The Plug-In unit terminals and receptacle
are designed to line up automatically when
plugged together. If the terminals are badly
bent and cannot be plugged into the recep-
tacle, the unit should be taken to the product
service center for replacement.
DO NOT attempt to clean, adjust or in
any way repair the Plug-In receptacle. If an
abundanceof liquid should accidentally spill
and collect inside the receptacle, call your
product serviceman.
The Master oven is vented througha duct which
is located under right rear surface unit. Cleanthis
duct frequently. To remove, lift rear surface
unit, remove reflector pan, and lift out duct. To
reposition, place solid part of duct over round
opening under the cooktop. Then position hol
*
in duct so it sets directly under round open"
in reflector pan. Duct must be in correct positl
so moisture and vapors from oven can be vente
during use.
NEVER COVER HOLE in oven vent duct with
aluminum foil or any other material. To do so
prevents the oven vent from functioning prop-
erly during cooking.
LAMP REPLACEMENT
Fluorescent
Surface Lamp
WHEN
CHANGING
A FLUORESCE
m
LAMP, DO NOT TOUCH THE METAL AT
ENDS OF LAMP.
a.
Push buttonseitherside of glasspanel covering
lamp and let swing down for access to lamp.
b. Roll lamp, one quarterturn, remove.
C.
Check type and wattage of lamp; replace with
same kind. Hold lamp near each end and insert
prongs into sockets.Gently roll lamp until it stops.
d. Connect electric power to range. Start
lamp;
seeinstructions o n
Surface Cooking pages.
a.
Remove the three slotted screws in lamp cover;
see diagram. Remove cover; replace lamp with
40 watt appliance lamp.
b.
Replace lamp cover with three screws.
c. Connect electric power to range.
e
29
Advertisement
