Light Bulb Replacement - Hotpoint RVM225WL Use And Care Manual

To replace
power at main
fuse or circuit
breaker panel
or pti plug.
Remove screw on right side of light compartment
cover and lower cover until it stops.
Oven Light
To replace your oven light, fwst
disconnect power at main fuse
or circuit breaker panel or pu~
plug. Remove the top @l by
taking out the 2 screws that hold
it in place.
24
REMOVE SCREW
Next, remove the single screw
located above door nem center
of oven that secures light housing.
Replace burned-out bulb with
a 30-watt incandescent bulb
your Hotpoint supplier.
Be sure bulbs to
be replaced are
cool before
removing. Break
the adhesive sed by
gently unscrewing
the bulbs. Replace
with 40-watt
incandescent bulbs ~B02X4253) available from
your Hotpoint supplier. High intensity 40-watt bulbs
hardware stores, may rdso be used for replacements.
Raise tight compartment cover and replace screw.
Connect electrical power to microwave oven.
Clean off the grease and
hood surfaces often. Use a solution
of warm water and detergent.
About 1 tablespoon of ammonia
may be added to the water. Take
care not to touch the filters and
enamel surfaces with this solution;
ammonia will darken meti.
dust on