Enable Data Format; Change Data Format For A Single Scan; Enable/Disable Data Formatter - Newland HR22 Dorada User Manual

Enter Setup

Enable Data Format

After enabling the Data Formatter, you may select a data format you want to use by scanning the
appropriate barcode below.
** Format_0

Change Data Format for a Single Scan

You can switch between data formats for a single scan. The next barcode is scanned using the data
format selected here, then reverts to the format you have selected above. For example, you may have set
your scanner to the data format you saved as Format_3. You can switch to Format_1 for a single trigger
pull by scanning the Single Scan – Format_1 barcode below. The next barcode that is scanned uses
Format_1, then reverts back to Format_3.
Note: This setting will be lost by removing power from the scanner, or turning off/ rebooting the device.
Single Scan – Format_0
Single Scan – Format_2
** Exit Setup
Format_2
Format_1
Format_3
Single Scan – Format_1
Single Scan – Format_3
118