Chapter 5 - Preparing Robomow; Adjust The Cutting Height; One-Time Setup - Robomow RC304 Original Operating Instructions

Chapter 5 – Preparing Robomow
Before using Robomow for the first time, you have to perform some simple preliminary settings.
Once the preparations are complete, your Robomow will be ready to mow your lawn.

5.1 Adjust the Cutting Height

Blade Cutting Range: 15 – 60 mm (0.6 – 2.4 inches)
To adjust the cutting height of the blade, do the following:
CAUTION! ALWAYS TURN THE SAFETY SWITCH OFF
BEFORE ADJUSTING THE CUTTING HEIGHT!
• Lift the front side of the mower.
• Turn the knob while pushing it down.
• To raise the cutting height, turn clockwise.
• To lower the cutting height, turn anticlockwise
• The cutting height is displayed at the side of the mower.
5.2 One-Time Setup (Step by Step)
Make sure the Safety Switch is on and the Power Box is
plugged in before starting the One-Time Setup process.
The mower is now ready to perform the One-Time Setup
process.
! !
IMPORTANT
To restart the One-Time Setup process press and hold STOP + Settings + Left
arrow buttons together for more than 4 seconds. This will invoke Factory Defaults ("Out of the Box"
settings).
5.2.1 Using the Operating Panel
Use the buttons on the Operating Panel as follows:
• Press the 'Right' or 'Left' arrows until your desired option
is displayed.
• Press OK to select the value shown on the display.
• Press 'Back' (STOP) to go back or to cancel.
5.2.2 Choose Measurements Units and Formats
Area / Distance
EU Meter
US Foot
Settings button
Temp. Clock
Celsius 24 Hours
12 Hours
Fahrenheit
(AM / PM)
Safety Switch
Cutting height adjustment
LOW
LOW
Right/Left arrows
ok
STOP
HIGH HIGH
29