Robomow RC304 Original Operating Instructions page 6

Transportation –
To safely move from or within the working area:
1. Press the STOP button to stop Robomow
2. Use the Remote Control (available as an accessory) to drive it from one place to another.
3. In case of different ground height level, switch off the Safety Switch, and carry the mower
by its carrying handle.
IMPORTANT! It is recommended to keep the original packaging for shipping purposes..
4. When transporting Robomow
IMPORTANT! After turning on the Safety Switch, always re-set the current day and
time, otherwise unexpected operation of the Robomow may occur.
Using Remote Control (Manual Mowing)
1. Mow only in daylight or in a good artificial light and avoid operating on wet grass.
2. Do not operate Robomow
long trousers; always make sure of your footing on slopes.
3. Use extreme caution when reversing direction the mower towards you.
4. Always switch on the motor according to instructions while standing away from the blade.
5. Do not mow manually in slope greater than 15 degrees or where a firm footing is not possible.
Maintenance and Special Instructions–
1. Always switch off the Safety Switch of Robomow
Robomow or replacing the blade. Never attempt to service or adjust the mower while it is in operation.
®
2. In case of abnormal vibrations, stop the mower, switch off the Safety Switch and check for any damage of the
blade. Replace worn or damaged blade to preserve balance. If vibration continues, call for service.
3. Use heavy gloves when inspecting or servicing the blade.
4. Do not perform maintenance when barefoot or wearing open sandals. Always wear suitable work shoes and long
trousers;
5. Replace worn or damaged parts for your safety.
6. Use only original equipment and accessories. It is not permitted to modify the original design of Robomow
modifications are made at your own risk.
7. Maintenance/ Servicing / Cleaning of Robomow
8. Keep all nuts, bolts and screws tight to be sure the machine is in safe working condition.
9. Warning! When there is a risk of a lightning storm, disconnect the Perimeter Wire from the Base Station / Perimeter
Switch, and the Power Box 230V/120V plug from the power outlet.
Batteries –
1. Do not open or damage the battery pack.
2. The battery pack should be replaced only by a service dealer.
3. The Battery Pack contains electrolytes. In case of an electrolyte leakage from the battery pack, the following
actions should be taken:
- Skin contact: Wash the contact areas off immediately with water and soap.
- Eye contact: Flush the eyes with plenty of clean water for at least 15 minutes immediately, without rubbing.
- Get medical treatment.
4. Ensure that the battery pack is charged using the correct charger recommended by the manufacturer. Incorrect
use may result in electric shock, overheating or leakage of corrosive liquid from the battery.
Product End of Use -
1. Robomow and its accessories should be collected separately at the end of their life to prevent waste electrical and
electronic equipment from ending up in landfill sites, to promote the reuse, treatment and recovery of electrical and
electronic equipment with the purpose to preserve, protect and improve the quality of the environment, protect human
health and utilize natural resources prudently and rationally.
2. Do not dispose of Robomow or any other part of it (including the Power Box, Base Station and Perimeter Switch) as
unsorted municipal waste – it should be collected separately.
3. Ask your local distributor/dealer about return and collection systems availablity.
4. Do not dispose the battery pack in a fire, and do not place used batteries in your household trash.
5. The battery must be collected, recycled, or disposed of in an environmentally sound manner.
.
®
over long distances switch off the Safety Switch.
®
when barefoot or wearing open sandals. Always wear substantial footwear and
®
before clearing blockage/ checking/ cleaning/ working on
®
should be according to manufacturer's instructions.
®
. All
®
5