Robomow RC304 Original Operating Instructions page 39

Screen Setting
Add Sub-Zone
P022
Update Distance
P023
To Sub-Zone
SmartMow
P024
(Default =
OFF
SmartMow
Edge Overlap
P025
(Default = 10 )
TurboMow
P026
(Default =
OFF
38
• Enables the addition of a Sub-Zone. Maximal number of Sub-
Zones may be different for each Robomow model.
• A1/A2/A3/A4 (name of the first available sub-zone) is displayed
- press OK.
• If the mower is not at the Base Station, then 'U044' ("Place the
mower in the Base Station") is displayed. Place the mower in the
Base Station and press OK.
• The mower will start moving towards the Sub-Zone.
• Scroll to set the area of the Sub-Zone and press OK.
• Note! This process is not a part of the One-Time Setup (see
Section 5.2)
• The area setting of a Sub-Zone can be later updated through the
'Area' menu of the Basic Settings (see Section 6.4.1)
• The distance to Sub-Zone's entry point can be update later
through menu P023
• This menu is shown only if a Sub-Zone has been defined.
• It allows to update the distance to Sub-Zone's entry point.
• Scroll to choose the required Sub-Zone (A1/A2/A3/A4) and press
OK to update the distance to the entry point.
• SmartMow feature allows more efficient mowing operation
through the smooth and continuous turns when reaching lawn's
edge.
• When this feature is enabled for the first time in a particular
zone, it may require the mower to cross the lawn and "touch"
the perimeter wire several times (to perform an initial calibration
of the algorithm), before it will start performing smooth turns at
lawn's edge.
)
• If there is more than one zone defined, then there is an option
to enable this feature for a particular zone or for the entire lawn
('All').
• Please note! This feature may not be equally efficient on all lawns
or on different sections of a particular lawn, especially if a lawn
area is small or has narrow areas, big islands or slopes.
• Allows adjusting the degree of overlapping with lawn's edge,
when performing the smooth and continuous turns in SmartMow
mode.
• Increasing this value will cause a higher overlapping with lawn's
edge (for better mowing results), but at some point may prevent
the mower from performing a smooth turn.
• If there is more than one zone defined, this setting may be set per
zone or for the entire lawn ('All').
• TurboMow feature allows faster and stronger mowing of a high
grass during the first cut of the season.
• When a mower is operated for the first time, or if the Factory
Defaults ("Out of the Box" settings - see Section 5.2) are invoked,
this feature is automatically set to ON to provide better mowing
results already after the initial mowing cycle. At the end of the
initial mowing cycle, the feature will be automatically disabled (set
to OFF).
)
• This menu allows to activate TurboMow feature manually. 'U094'
("Raise mowing height when activating the TurboMow mode.")
will be displayed. At the end of the cycle the feature will be
automatically deactivated (set to OFF).
• When the TurboMow feature is activated, the initial mowing cycle
will be longer and noisier than the next mowing cycles.
Description Options
/ / /
A1 A2 A3
A4
100
All
/ /
L1 L2 L3
/ / /
A1 A2 A3
A4
/
On OFF
5-30
/
On OFF