Robomow RC304 Original Operating Instructions page 50

9.4.1 Description of No-Depart Codes
Code
None. Automatic departure is working properly
00
Mower's battery is not yet in the required state
01
forautomatic departure
Inactive Time is activated. No automatic
02
departure during Inactive Time
Mowing cycle is completed. Waiting for the next
03
scheduled operation
Humid conditions or rain were detected during
04
last 30 minutes.
The mower is switched off
05
User response (interaction) is required in order to
07
continue current operation
Multiple consecutive mowing operations were
shorter than expected. Usually accompanied by
08
U018 ("Operation time is shorter than expected")
One-Time setup is running
09
Automatic operation is disabled by menu P021
11
(see Section 6.4.2)
Automatic operation is put on pause bythe Power
12
Box
All week days are set as inactive days
13
The mower is being charged directly by the
14
Power Box (via the DC connector)
Battery cells are being balanced in special
15
charging mode
The mower is in the Base Station, but there is no
16
charging voltage supply
Low ambient temperature
17
Sub-Zone entry problem. The mower was unable
18
to enter one of the Sub-Zones
Description Corrective Action
None. Wait for the end of current charging cycle
None. Wait for the end of current charging cycle.
May take longer than usual
None. Validate Inactive Time settings (see
Section 6.4.1.3)
None
- None. If the rain has stopped, wait for another
30 minutes at least
- If there was no any raining at all, consider
adjusting rain sensor's sensitivity (see P008 in
Section 6.4.2) or call Robomow Hotline
Switch on the Safety Switch
Acknowledge the error message
- Inspect mower's blade and drive wheels.
- Battery run-time may be too short.
One-Time setup should be completed before the
automatic operation can start
Enable automatic operation through menu p021
Enable automatic operation via the Power Box.
Validate Inactive Time settings (see Section
6.4.1.3)
Disconnect the DC cable from the mower. Put
the mower in the Base Station.
None. Wait for the end of current charging cycle.
May take longer than usual.
- Inspect Power Box's connection to the Base
Station
- Confirm that nothing is blocking the charging
pins
None. The mower will automatically depart
when it gets warmer.
Refer to U090-U093 in Section 9.3
49