Robomow RC304 Original Operating Instructions page 46

Display Message
Check mowing
0022
motor
Check power
0023
Base problem
0026
Start Elsewhere
0027
Cross Outside
0028
Start Inside
0030
Stuck in place
0031
Check mowing
0060
hours (%)
Decrease
0061
Inactive Time
Probable Cause/Event
- Mowing motor has faced over-
current for too long in the Base
Station before starting the operation.
- See E4 in the above table
- Robomow fails to enter the Base
Station several consecutive times.
- Drive wheel motors have been
working under severe load during
automatic or manual operation.
- The Perimeter Wire is too close to
the edge.
- The lawn slope is too steep.
- Robomow does not succeed to
turn in place at the edge and it
causes the mower to slip out of the
designated area.
- Robomow has slipped out of the
Perimeter Wire lope because of
sloping area or wet grass.
- Automatic operation is initiated
while the robot is placed out of the
Perimeter Wire loop.
- See E1 in the above table
- The mowing hours % value you
have set is too high for your lawn
area.
- See E8 in the above table
Corrective Actions
- CAUTION – Switch Off the Safety Switch
before checking the blade.
- Remove the mower from the Base Station.
Inspect the blade for foreign material or debris
preventing rotation.
- Adjust the Base Station position.
- Clean the contacts with a brush or piece of
cloth.
- Check to insure the mower is not stuck,
causing the drive wheels to slip.
- Check the ground around the mower for holes
or indentations. Fill with ground and level off.
- Check if the drive wheels are free to rotate
and nothing is blocking them.
- Move the mower away from this particular
location and restart operation.
- Remove the wire towards the inner part of the
lawn.
- Do not include this area because of its steep
slopes.
- Fill holes and pits in the ground.
- Increase the cutting height.
- Place the mower inside the lawn and renew
the operation.
- Decrease the mowing hours % you have set
for the zone(s) in your lawn.
45