Robomow RC304 Original Operating Instructions page 31

5.2.3 Set Day and Time
• Scroll to set the Day and press OK to confirm.
• Scroll to set the Time and press OK to confirm.
5.2.4 Main Zone Area
• Scroll to select an approximate area (EU- m² / US- ft²) for the Main Zone,
where the Base Station is installed.
If an additional zone (Sub-Zone or Separated Zone) exists, do not include it in
main zone's area (it will be set separately).
Note – It is necessary to complete the above settings (5.2.2 – 5.2.3) in order to operate the mower. Every
press on the STOP button will change the screen one step back in the process.
5.2.5 Test Base Station Position
• After setting the area,
displayed.
• Place Robomow inside the lawn, approximately 3 m (10 ft.) in
front of the Base Station, facing the Perimeter Wire and press
OK to start the test.
• Robomow drives towards the Base Station:
If the mower does not start the test, then one of
the following messages will be displayed:
No Wire Signal
E3 (
Box is connected to the power outlet and that
the Extension Cable is connected at both ends,
from the Power Box to the Base Station.
Swap wires in plot connector
U029
(
Perimeter Wire has been connected in the
opposite direction. Swap the wires at the plot
connector.
• Robomow will enter the Base Station, drive back, wait in front of
the Base Station, and display
(
Reposition Base Station)
If U051
displayed:
• Move the Base Station slightly to align it with
the Perimeter Wire.
• Check for any obstacles that may interfere
with the mower's entrance to the Base
Station.
(
Peg Base
• While 'U002'
of the Base Station to secure it to the ground and press OK.
30
U001 (Test Base Station Position) is
–
) Confirm that the Power
–
The
)
(
Peg Base
U002 ).
message is
)
is displayed, insert the remaining Stakes