GETTING STARTED
Step 3a. Digital TV Reception with Conventional TV (no satellite or cable service)
Follow this diagram if you have a conventional TV, no satellite or cable service. Digital
and analog channels can be viewed by connecting the HDTV Digital Receiver.
CONVENTIONAL TVI MONITOR
RAUDIO L
VIDEO S ·VlDEO
INPUT
NOTE: S-VIDEO AND VIDEO CABLES
NOT INCLUDED
HDTV DIGITAL RECEIVER
Mooet..NO.
A~O
TEL LINE
Panasonlc!>
HON
DIGtT~
RECEIVER
R·AUDlo-
(Of
@
o
0>
H·SYNC!.
DIGITAL OUTPUT
SERIAL NO.
AC 120V 60Hz
MAX ......PS
MANUFACTURED
SATELLITE
R
o
IN IiICH3
0
DCH4
ANT IN
o
HDTV DIGITAL RECEIVER, CONVENTIONAL TV/MONITOR
(NO SATELLITE OR CABLE ANTENNA)
Procedure
Select 480i mode by using the Video Out button on the front of the HDTV Digital Receiver.
•
Connect the antenna cable to the ANT IN.
•
Connect the RF OUT to the ANT IN of the television or connect Audio and Video cables as
shown.
Note:
Connect either the S- Video or video input/output as shown above.
S-Video will provide better picture quality.
If both S-Video and video are connected, S-Video will override video.
•
Connect audio cables from the left and right NTSC audio output jacks on the HDTV Digital
Receiver to the left and right audio input jacks on the TV.