Step 3A. Digital Tv Reception With Conventional Tv (No Satellite Or Cable Service) - Panasonic TU-HDS20 Operating Instructions Manual

G S
ETTING TARTED

Step 3a. Digital TV Reception with Conventional TV (no satellite or cable service)

Follow this diagram if you have a conventional TV, no satellite or cable service. Digital
and analog channels can be viewed by connecting the HDTV Digital Receiver.
SATELLITE
IN
ANT IN
M ODEL NO.
SERIAL NO.
AC 120V 60Hz
M AX AMPS
M ANUFACTURED
HDTV DIGITAL RECEIVER, CONVENTIONAL TV/MONITOR
Procedure
•
•
•
Note:
•
32
CONVENTIONAL TV/ MONITOR
ANT IN
RF OUT
CH 3
CH 4
R-AUDIO-L
RGB/YP P
B R
H-SYNC-L
DIGITAL OUTPUT
(NO SATELLITE OR CABLE ANTENNA)
Select 480i mode by using the Video Out button on the front of the HDTV Digital Receiver.
Connect the antenna cable to the ANT IN.
Connect the RF OUT to the ANT IN of the television or connect Audio and Video cables as
shown.
Connect either the S-Video or video input/output as shown above.
• S-Video will provide better picture quality.
• If both S-Video and video are connected, S-Video will override video.
Connect audio cables from the left and right NTSC audio output jacks on the HDTV Digital
Receiver to the left and right audio input jacks on the TV.
AUDIO
S -VIDEO
VIDEO
R L
INPUT
HDTV DIGITAL RECEIVER
P P Y
R B
R B G
R-AUDIO-L VIDEO S-VIDEO
DIGITAL
AUDIO OUT
NTSC OUTPUT
(AC-3)
NOTE: RF CABLES, S-VIDEO AND
VIDEO CABLES NOT INCLUDED
®
HDTV DIGITAL RECEIVER
WARNING
!
RISK OF ELECTRIC SHOCK
DO NOT OPEN
DISTRIBUTED BY
MATSUSHITA ELECTRIC
CORPORATION OF AMERICA
ONE PANASONIC WAY,
SECAUCUS, NEW JERSEY 07094
TEL LINE
ASSEMBLED IN MEXICO