Panasonic TU-HDS20 Operating Instructions Manual page 72

Hide thumbs Also See for TU-HDS20:
Table of Contents

Advertisement

ROLLER GUIDE MENU
OPERA
TIONS
Setup: Ant Setup - Auto Scan
The Auto scan allows you to retrieve all of the antenna or unscrambled cable channel.
When you press the ACTION key while the START button is highlighted, the
automatic scan of all available RF channels will begin. During Auto Scan mode only
the following commands will function:
Power Off (POWER key)
Stop auto scan (ACTION KEY)
GUIDE Key
The auto scan normally takes several minutes to complete. To inform the user that the
scanning is still in progress: the current channel being scanned, the current percent of
scan completed, and a bar meter is displayed, as shown in the figures below. If the
channel has been received, the channel number moves to the right and a "Received"
message is displayed. If no channels have been received after the scan is completed
a message will be displayed indicating that the auto scan has detected no channel
and that the user might want to check the input signal connections. Video will not be
present in the background during Auto Scan.
Ant Setup Setup - Auto Scan
Procedure
CJ
In the Ant Setup menu, press'" button to highlight Auto Scan.
CJ
Press
~
button and ACTION button to start Auto Scan. After completion of the auto scan,
press ACTION and press .... button to return to Sat setup.
CJ
Press ACTION button to stop the Auto Scan if necessary.

Advertisement

Table of Contents
loading

Table of Contents