Panasonic TU-HDS20 Operating Instructions Manual page 14

FRONT AND REAR VIEW OF THEHDTV DIGITAL RECEIVER
Rear Panel
NTSC OUTPUTS
AC-3 / PCM Output
jack
DIGITAL OUTPUTS
H, V Jacks
,......--+----...-P~
P
B -
Y
R - B - G
<0
<0
Q
<0 <0
m
C
R-JlUDlO.L VlCEO &VICEO llGlTJIL
1 - - -.......
.--+---------1
AlDlOaJT lE...1JI£
NTSC 0l1TPUT
(PC-3)
RGBIYPSP
R
Switch
SATELLITE IN jack CH3/CH4 Switch RF Out jack
I
f>NTIN
o
AN IN jack
ANT IN
SATELLITE IN
RFOUT
CH3/CH4 Switch
YPBP
R /
RGB Jacks
RGBNPBP
R
Switch
DIGITAL OUTPUTS
NTSC OUTPUTS
H, V jacks
AC 3/PCM OUTPUT
MODEM
Use to connect an off-air antenna or cable TV signal to the
HDTV Digital receiver.
Use to connect DIRECTV satellite signal to the HDTV Digital
Receiver.
Use to connect the HDTV Digital Receiver to your TV.
If a coaxial cable is used to connect the digital receiver to
your TV, you must set the CH3/CH4 switch to either CH3 or
CH4.
Primary jacks used to connect the HDTV Digital Receiver to a
DTV Compatible Television.
Selects either RGB or Component video (Y,PB.PR) signals
according to your TV/Monitor.
Outputs either Component Video or RGB signal .
Use to connect the HDTV Digital Receiver to a Conventional
TV.
Horizontal and Vertical sync jacks used with RGB for high-
end monitors, video projectors etc..
Use to connect your HDTV Digital Receiver to a Dolby Digital
AC-3 receiver or decoder.
Use to connect a phone line to the HDTV Digital Receiver to
enable DIRECTV pay per view services.