Avery Dennison Monarch 9855 Operator's Handbook, Maintenance, Service & Parts Manual page 99

4. Clean the platen roller when you see significant adhesive build-up or a
label is wrapped around the platen roller. Use a dry, soft-bristle brush,
such as a toothbrush, to clean the standard (black) platen roller. If the
brush does not remove all the adhesive
♦
Use isopropyl alcohol ONLY on the standard (black) platen roller.
Moisten a cotton swab with isopropyl alcohol and run the cotton swab
across the platen roller. Turn the platen roller with your finger to make
sure the platen roller is clean all the way around.
After cleaning, feed several inches of supply through without printing to
remove any remaining isopropyl alcohol.
5. Moisten a cotton swab with isopropyl alcohol. Rub the cotton swab
across the peel bar and remove any build-up.
6. Moisten another cotton swab with isopropyl alcohol. Rub the cotton swab
across the printhead and remove any build-up. You may need to use a
printhead CLEAN-STRIP if the printhead is extremely dirty or you see
streaks on the supply.
Printhead
Care & Maintenance 9-3