Avery Dennison Monarch 9855 Operator's Handbook, Maintenance, Service & Parts Manual page 19

Place the roll of supply on the supply holder. For labels, the supply
4.
unrolls from the top or the bottom. For tags, make sure the supply
unrolls from the bottom, because tag rolls are wound face in.
Note: Do not pick up the printer by the supply holder.
5. Adjust the supply holder guides so the sides barely touch the roll. Make
sure the supply roll turns freely.
If you are using fan-fold supplies, place the supply stack behind
the printer, label side facing up.
Push down on the supply lever to unlock the supply guides.
6.
Lay the label strip across the supply guide so that a few inches extend
7.
past the front of the printer. Tuck the supply under the nibs and in
between the die cut sensor. Do not feed supply between the supply
roller and deflector.
Suppl y Holder
Guides
Suppl y Roller
Loading Supplies 2-3