Bosch GCO 2000 Professional Original Instructions Manual page 27

OBJ_BUCH-1063-001.book Page 27 Thursday, December 10, 2009 1:03 PM
Working Advice
Before any work on the machine itself, pull
the mains plug.
General Cutting Instructions
Do not touch the cutting disc after working
before it has cooled. The cutting disc be-
comes very hot while working.
Make sure that the spark guard 20 is prop-
erly mounted. Sparking occurs when cutting
metal.
Protect the cutting disc against impact, shock
and grease. Do not subject the cutting disc to
lateral pressure.
Do not strain the power tool so heavily that it
comes to a standstill.
Excessive feed considerably reduces the per-
formance capability of the machine and short-
ens the service life of the cutting disc.
Use only cutting discs that are suitable for the
material to be worked.
Permissible Workpiece Dimensions
Maximal workpiece sizes:
Workpiece Form
110 x 110
180 x 85
130 x 130
Bosch Power Tools
Minimal workpiece sizes
(= all workpieces that can be clamped via the
clamping spindle 8):
Length 80 mm
Adjusting the Depth Stop (see figure H)
In the delivery condition of the machine, the
depth stop 16 is adjusted in such a manner that
a new 355 mm cutting disc does not touch the
base plate when cutting.
To compensate the wear of the cutting disc, the
depth stop can be set deeper.
When using a new cutting disc, the depth stop
must then always be set back to the original po-
sition.
– Bring the power tool into the working posi-
– Loosen lock nut 25 with the supplied ring
– Swing the tool arm with the handle 3 to the
– Screw the depth stop 16 in clockwise or an-
Mitre/Bevel Angle
0° 45°
– Slowly guide the tool arm upward and tight-
125 Ø 100 Ø
Transport
– Always carry the power tool by its transport
82 x 82
90 x 75
75 x 75
Always adjust the depth stop in such a man-
ner that the cutting disc does not touch the
base plate when cutting.
tion. (see "Releasing the Machine (Working
Position)", page 25)
spanner 14 (13 mm).
requested position.
ticlockwise direction until the screw head
touches the housing.
en the lock nut 25.
handle 18.
The power tool should always be carried by
two persons in order to avoid back injuries.
When transporting the power tool, use only
the transport devices and never use the
protective devices.
1 609 929 U62 | (12/10/09)
English | 27