Declaration Of Conformity - Bosch GCO 2000 Professional Original Instructions Manual

OBJ_BUCH-1063-001.book Page 24 Thursday, December 10, 2009 1:03 PM
24 | English

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 61029 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, Dept. PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 24.11.2009
Assembly
Avoid unintentional starting of the ma-
chine. During assembly and for all work on
the machine, the power plug must not be
connected to the mains supply.
Delivery Scope
Carefully remove all parts included in the deliv-
ery from their packaging.
Remove all packaging material from the machine
and the accessories provided.
Before starting the operation of the machine for
the first time, check if all parts listed below have
been supplied:
– Cut-off grinder with mounted cutting disc
– Ring spanner 14
Note: Check the power tool for possible dam-
age.
Before further use of the machine, check that all
protective devices are fully functional. Any light-
ly damaged parts must be carefully checked to
ensure flawless operation of the tool. All parts
1 609 929 U62 | (12/10/09)
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Stationary or Flexible Mounting
To ensure safe handling, the machine must
be mounted on a level and stable surface
(e. g., workbench) prior to using.
Mounting to a Working Surface (see figure A)
– Fasten the power tool with suitable screw
fasteners to the working surface. The holes
11 serve for this purpose.
Flexible Mounting
In the exceptional case that it should not be pos-
sible to firmly bench-mount the power tool, you
can provisionally place the legs of base plate 12
on a suitable surface (e. g. a workbench, level
floor, etc.) without bolting the machine down.
Dust/Chip Extraction
Dusts from materials such as lead-containing
coatings, some wood types, minerals and metal
can be harmful to one's health. Touching or
breathing-in the dusts can cause allergic reac-
tions and/or lead to respiratory infections of the
user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in con-
nection with wood-treatment additives (chro-
mate, wood preservative). Materials containing
asbestos may only be worked by specialists.
– Use dust extraction whenever possible.
– Provide for good ventilation of the working
place.
– It is recommended to wear a P2 filter-class
respirator.
Observe the relevant regulations in your country
for the materials to be worked.
Bosch Power Tools