Nikon D700 Repair Manual page 161

Inspection and adjustment of AE CCD positioning
＊ Under the environment where the AE-CCD positioning is adjusted, use the reference body and confirm
results.
・ In case the measured value is out of standard, check whether there is no deviation of the focus area
positioning.
・ In case the measured value is out of standard, change the environment of measurements. (e.g. setting place/
direction, room brightness, etc)
Caution) Whenever the metering FP unit is disassembled/replaced or the main PCB is replaced, make this
adjustment.
Procedure
① Make temporary assembly of the bottom cover, as the tripod is used.
② Mount "AF50/1.4D" on the camera, and fix them on the tripod horizontally.
③ Connect the camera and PC via USB cable (UC-E4).
Connect the camera and PC via cable MC-31 (USB is available in case of inspection).
④ Connect the AC adapter EH-5.
＊ Be careful NOT to cause a short-circuit at uncovered portions.
⑤ Attach the AE-CCD positioning tool (J63097) in the color viewer (J63070), and turn power ON.
⑥ Keep the 0.7-m distance between the front face of the AE-CCD positioning tool and the reference surface of
the camera. Set the camera AF to manual, and rotate the focus ring to set to "0.7 m".
⑦
Start up the inspection and adjustment software for D700 (J65119), and select "Inspection and Adjustment for
AE CCD POSITION" then "Set Camera for AE CCD POSITION" to lighten the focus area.
Looking through the viewfinder, move the camera so that the focus area of the camera coincide with the
grid lines of the AE-CCD positioning tool.
＊ Set the camera and AE-CCD positioning tool horizontally.
⑧ Select "Inspection and Adjustment for AE CCD POSITION".
＊ Cover the camera with a black cloth, etc, when measured.
⑨ By following the instructions on PC, adjust the AE-CCD position by using the screw (a and b).
⑩ After confirming the tilt is within standard, fix the three screws with the screwlock.
Device
COLOR VIEWER
Changed page △× 2
△（Addition）
《RS232C or USB communication》
△（Revision）
AE-CCD positioning tool
（J63097）
AF 50/1.4 Ｄ
Approx 0.7 m
Color viewer (J63070)
J63070
AF50 / 1.4D
LENS AF50/1.4D
- A61 ･ D700 -
Attaching surface of the imaging-PCB
J18266
AE/CCD USE CHART BOARD FOR D3
INC
VBA22001-R.3754.A
J63097
August, 19,2008