Table of Contents
Advertisement
Basic Operations
• Adjusting the bass
2-1.
Select "BASS".
3-1. Press the
[~II
ENT] button.
3-2. Push the [P.CH] button upward or
downward to adjust the gain from -6 to +6
(The factory default setting is "0").
3-3. Press the
[~II
ENT] button to return to the
previous mode.
• Adjusting the treble
2-1.
Select "TREBLE".
3-1. Press the
[~II
ENT] button.
3-2. Push the [P.CH] button upward or
downward to adjust the gain from -6 to +6
(The factory default setting is "0").
3-3. Press the
[~II
ENT] button to return to the
previous mode.
• Adjusting the sound restorer
The sound restorer enriches the playback of all
types of music files that have undergone any
level of data compression.
2-1.
Select
"s
RESTORER".
3-1. Push the [P.CH] .button upward or
downward to adjust.
Each time you push the [P.CH] button, the
sound restorer changes in the following
order:
"OFF"
~
"1"
~
"2"
~
"3"
*
The factory default setting is "OFF".\
Set this adjustment in accordance with the
music source used
OFF: For music sources compressed at
high bit rate
1:
For music sources compressed for high
quality at low bit rate
2: For music sources compressed for
standard quality at low bit rate
3: For music sources compressed for low
quality at low bit rate
• Adjusting the balance
2-1.
Select "BALANCE".
3-1. Push the [P.CH] button upward to
emphasize the sound from the right
speaker, push the button downward to
emphasize the sound from the left speaker.
*
The factory default setting is "0".
(Adjustment range: L12 to R12)
• Adjusting the fader
"FADER" can be adjusted only when the
speaker system is set to "2WAY" or "NORMAL".
2-1.
Select "FADER".
3-1. Push the [P.CH] button upward to
emphasize the sound from the front
speaker, push the button downward to
emphasize the sound from the rear
speaker.
*
The factory default setting is "0".
(Adjustment range: R12 to F12)
• Setting high pass filter
"HPF" can be adjusted only when the speaker
system is set to "NORMAL".
2-1.
Select "HPF".
3-1. Push the [P.CH] button upward or
downward to select the setting. Each time
you push the [P.CH] button, the setting
changes in the following order:
"THRGH"
~
"50Hz"
~
"80Hz"
~
"125Hz"
*
The factory default setting is "THRGH"
(through).
• Setting low pass filter
"S-W LPF" can be adjusted only when the
speaker system is set to "NORMAL" .
*
If subwoofer function is set to "ST" or "MONO",
"S-W LPF" can be selected.
2-1.
Select "S-W LPF".
3-1. Push the [P.CH] button upward or
downward to select the setting.
Each time you push the [P.CH] button, the
setting changes in the following order:
"THRGH"
~
"50Hz"
~
"80Hz"
~
"125Hz"
*
The factory default setting is "THRGH"
(through).
DXZ775USB
15
Advertisement
Table of Contents
