Troubleshooting - Piazzetta P958 Instructions For Installation, Use And Maintenance Manual

6.5 TROUbLEShOOTING

A list of situations that could occur and instructions on what to do is given below.
The stove is in the startup phase, the readout "NO LIT" appears on the display and the warning
buzzer sounds (if set).
The stove does not light because the flue gas outlet sensor does not detect an increase in temperature
(sign that the combustion process has not been triggered) or because there is no pellet feed.
If the stove is new or has gone out having fully burned the pellets in the grate, even though the hopper
is full, it may be that in the ignition phase the pellets are not being fed into the firebox due to the auger
not yet having been fully loaded.
Shut the stove down by pressing the ON/OFF key down for a few seconds.
The warning buzzer stops.
The readout CLEANING BRAZIER appears on the display and when the stove has cooled the readout
OFF appears.
Empty the grate completely and set a new ignition cycle (see the table LOAD AUGER in the section
PARAMETERS MENU).
Repeat the ignition process as described above.
a
Do not empty the contents of the grate into the hopper because there may be unburnt pellets present.
a
If the stove occasionally fails to ignite it could be caused by:
- pellet composition or size not in compliance with the specifications given in this booklet (see the "FUEL" section);
- insufficient mains voltage.
In the above cases any call-out of the service centre is not covered by the warranty, since the problem is not due to a defect in the
product.
The stove is in the START PHASE I and is turned off by the user pressing the ON/OFF key.
The readout "EMPTY BRAZIER" appears on the display.
Empty the grate completely before setting a new ignition cycle.
Keep the ON/OFF key pressed down to make the readout disappear and return to the initial display.
a
Do not empty the contents of the grate into the hopper because there may be unburnt pellets present.
28
FAILED IGNITION
Description
SWITCHING OFF DURING THE START PHASE
Description
H07026300 / DT2000786 – 00
DT2012309-00
Display
!
N O
L I T
1
C L E A N I N G
B R A Z I E R
. c
1 2 : 0 0 2 2
1
DT2012310-00
Display
E M P T Y
B R A Z I E R
1
DT2012311-00