Startup And Normal Operation - Piazzetta P958 Instructions For Installation, Use And Maintenance Manual

6.4 STARTUP ANd NORMAL OPERATION

• Before proceeding with lighting the stove:
a
ensure that the hearth door is well closed.
C O N T R O L
• Check that the pellet hopper is full or at least contains enough pellets
for the stove to run for the desired period.
.
1 2 : 0 0 2 2 c
• When the stove is connected to the power supply but is not yet lit, the
1
display will show the readout "OFF" and in the lower half the current
time, the measured temperature and the previously set power and
fan settings.
S T A R T
P H A S E I
Action
1 2 : 0 0 2 2
c
A cycle starts with three phases which take the stove into the normal
operating mode:
1
CONTROL (first 20 seconds)
• The lighter (glow plug) activates.
S T A R T
P H A S E I I
. c
1 2 : 0 0 2 2
Hold the ON/OFF key
1
down for several
seconds
START PHASE I
• The extractor fan starts up.
• The fuel-loading auger is activated and starts to feed pellets into the
START PHASE II
• If the lighter has triggered the combustion process, the fuel-loading auger
• If during the startup phase the sensor on the flue gas outlet shows a rise in
Description
grate.
increases to allow a period of stabilisation and correct combustion of the pellets
in the subsequent normal operating mode.
temperature (sign that the combustion process is underway), the stove is
considered to be lit and goes into the normal operating mode.
Fig. 56
0 9 : 5 3
1
STARTUP
H07026300 / DT2000786 – 00
DT2012018-01
O F F
. c
2 0
Display
C O N T R O L
C O N T R O L
C O N T R O L
1 2 : 0 0 2 2
1
1 2 : 0 0 2 2
1 2 : 0 0 2 2
1
1
S T A R T
P H A S E I
S T A R T
S T A R T
P H A S E I
1 2 : 0 0 2 2
P H A S E I
1
1 2 : 0 0 2 2
1 2 : 0 0 2 2
1
1
S T A R T
P H A S E I I
S T A R T
S T A R T
P H A S E I I
1 2 : 0 0 2 2
P H A S E I I
. c
1
1 2 : 0 0 2 2
DT2040051-07
1 2 : 0 0 2 2
1
1
. c
.
c
. c
c
c
c
. c
. c
25