Fairing Lowers - Buell 2002 S3T Service Manual

HOME

FAIRING LOWERS

REMOVAL
Right Side
1. See Figure 2-122. Remove bottom screw (2), nylon
washer (3) and locknut (6) from bracket (4).
2. Remove two upper screws (2), nylon washers (3) and
locknuts from fairing. Remove fairing.
Left Side
1. Remove seat and fuel tank screw. See
2. See Figure 2-122. Remove screw (2), clamp (7), nylon
washer (3) and locknut (6) from left fairing lower (8).
3. Disengage clamp (7) from metal bracket on fairing lower.
4. Lift fuel tank and remove left fairing lower.
INSTALLATION
Right Side
1. See Figure 2-122. Attach fairing lower (1) to bracket (4)
with screw (2), nylon washer (3) and locknut (6).
2. Install two screws (2), nylon washers (3) and locknuts (6)
to air cleaner cover bracket.
Left Side
1. Lift fuel tank and insert fairing lower lip over frame tube.
2. See Figure 2-123. Align clamp with metal bracket on fair-
ing lower. Place nylon washer between clamp and metal
bracket. Insert screw through clamp, nylon washer, metal
bracket and opposite side of clamp. Fasten with locknut.
3. Tighten fuel tank screw to 18-23 ft-lbs (24-31 Nm). Wait
five minutes and tighten again to 18-23 ft-lbs (24-31 Nm).
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control which could result in death or serious
injury.
4. Install seat. See 2.35 SEAT.
2.35 SEAT.
WARNING
1. Right Fairing Lower
2. Screw (4)
3. Nylon Washer (3)
4. Bracket
5. Wellnut (2)
6. Locknut
5
7. Clamp
8. Left Fairing
Lower
1
3
4
2
3
2
Figure 2-122. Fairing Lowers
8310
Figure 2-123. Left Fairing Lower Clamp
2002 Buell S3T: Chassis
2.38
8
2
7
2
3
6
2-73