Buell 2002 S3T Service Manual page 202

HOME
11 1
WARNING
The next step requires using a press. Wear eye protec-
tion and make certain set-up is stable. The pressure
involved could cause parts to "fly out" with considerable
force. Inadequate safety precautions could result in
death or serious injury.
10. See Figure 3-74. Mount the left crankcase half and fly-
wheel assembly on a press table, supporting crankcase
on parallel bars. Press on end of sprocket shaft with
arbor press until flywheel assembly is free from crank-
case half. Do not drive flywheel assembly from crank-
case half as flywheels may be knocked out of alignment.
NOTE
See Figure 3-74. If it is necessary to remove either the pinion
shaft bearing (11) or sprocket shaft bearing (4 and 9), pro-
ceed as follows:
11. Gearshaft bearing will remain on flywheel pinion shaft.
Remove retaining ring, and bearing may be slipped off
pinion shaft.
12. See Figure 3-76. Place flywheel assembly in FLYWHEEL
FIXTURE (Part No. HD-44358). Pull sprocket shaft bear-
ing with SPROCKET SHAFT INNER TIMKIN BEARING
REMOVER (Part No. HD-44404) and ALL PURPOSE
CLAW PULLER (Part No. HD-95635-46) using bolts in
place of jaws. Insert a penny (or suitable coin) between
shaft and claw puller to avoid damaging shaft.
13. See Figure 3-77. Use CRANKSHAFT BEARING TOOL
(Part No. HD-94547-101) to remove sprocket shaft outer
races.
Retaining
Ring
Right Crankcase Half
b0804a3x
3-52 2002 Buell S3T: Engine
WARNING
Bearing
Bearing Race
Retaining
Ring
Sprocket Shaft Bearing
Figure 3-75. Crankcase Assembly
3528a
Press on end of
sprocket shaft
Figure 3-74. Pressing Flywheel from Crankcase
Breather Hose
Fitting
**Gearshaft
Bearing
Bearing Cup
*Shim
Snap
Bearing
Ring
Cup
* See Table 3-18
** See Table 3-19
Left Crankcase Half
Bearing
Outer
Bearing
Spacer
Oil Seal