Buell 2002 S3T Service Manual page 159

HOME
a. Remove rear tie bar using a swivel socket.
b. See Figure 3-4. Detach front tie bar (1) and clutch
cable clamp (3). Remove tie bar bolt (2), clutch
cable clamp (3), washer (4) and locknut (5).
c. Remove washer and nut to detach front upper tie
bar (11) from isolator (8).
18. Detach front isolator (8). Remove front isolator bolt (6),
nut (10), D-washer (9) and washer (7).
19. See Figure 3-3. Remove isolator bolt (7) and lockwasher
(6) on each side.
20. Slowly raise floor hoist until rubber isolators (5) can be
removed. Frame will rise while engine remains secured
to lift by crating strap.
NOTE
Rubber isolators align with a frame mounted metal pin.
21. Raise frame and walk forward over and away from the
engine.
22. If necessary, remove rear swingarm. See
ARM.
23. If necessary, detach swingarm mount block from power-
train by removing bolts (3, 4), washers and locknuts.
b0251x3x
Figure 3-2. Supporting the Engine
b0202x3x
1
6
7
2.19 SWING-
b0730x3x
Crating
Strap
2
1.
2.
3.
4.
3
5.
6.
4
7.
5
Figure 3-3. Rear Tie Bar Assembly
1. Front Lower Tie Bar
2. Tie Bar Bolt
10
3. Clutch Cable Clamp
9
4. Washer
5. Locknut
6. Front Isolator bolt
7. Washer
8. Front Isolator
9. D-Washer
10. Nut
11. Front Upper Tie Bar
5
3
1
4
2
7
6
Figure 3-4. Front Tie Bar Assembly
2002 Buell S3T: Engine
Ground Strap
Rear Isolator
Swingarm Mount
Block Bolts
(2, upper)
Swingarm Mount
Block Bolts
(2, lower)
Rubber Isolator (2)
Lockwashers (2)
Isolator TORX
Bolts (2)
8
11
3-9