Scanning The Programmable Memory - Yaesu FTM-400DR Operating Manual

10
Press
The display will return to the previous screen, and the memorized frequency and
memory channel number will be displayed.
1
Switch to the memory mode
2
Recall the PMS memory of the upper frequency or lower frequency
3
Press briefly
The function menu will be displayed.
Touch
Tip When
touch
The programmable memory scan will be started.
Tips • The scan can also be started by pressing the
longer.
• When a signal is received, the scanning stops for three seconds and then the scanning starts
again.
• To stop the scanning, either touch
will not transmit in this case).
• The squelch level may be adjusted using the following procedure during scanning.
Touch
When the upper and lower frequencies are not set correctly, the programmable memory scan will not
work.
80
is not displayed in the function menu,
or to switch the menu.
button on the microphone for one second or
or
or press the microphone button (the radio