Memory Scan - Yaesu FTM-400DR Operating Manual

The FTM-400DR transceiver will scan the frequencies registered in the memories in the
order of the memory channel number.
1
Switch to the memory mode
2
Press briefly
The function menu will be displayed.
3
Touch
Tip When
touch
The scanning will start from the lowest to the highest
memory channel number.
During scanning, the decimal point of the frequency
display will blink.
When a signal is received, the scan will stop for three
seconds before starting to scan again.
Tips • The scan can also be started by pressing the
longer.
• The scanning direction (UP/DOWN) can be set using
set-up menu.
• The action to be taken when scanning is stopped can be set using
• The squelch level may be adjusted using the following procedure during scanning.
Touch
●
To stop the scanning, either touch
radio will not transmit in this case).
74
is not displayed in the function menu,
or to switch the menu.
button on the microphone for one second or
in the set-up menu (refer to the previous page).
or
or press the microphone
in the
button (the