JUMO LOGOSCREEN Operating Instructions Manual page 52

7 Device manager
Close device
manager
Log-in and
log-off
Device
information
Device
audit trail
Configuration
A
Parameter-
ization
Service
52
Close the device manager and reactivate the previous visualization.
v Chapter 7.1 "Logging in and logging off" (Page 53)
This function provides you with information on the hardware and software
components of the instrument. The momentary values of all the internal and
external inputs can also be checked.
The control knob can be rotated to display every single table. The function is
ended by pressing the control knob.
This function can be used to display the audit trail for the device.
The audit trail differs from the alarm and event lists.
v Further information can be obtained from the Operating Manual
B 70.6580.0.
The function is ended by pressing the control knob.
This function can be used to alter the configuration of the recorder.
v Further information can be obtained from the Operating Manual
B 70.6580.0.
An alteration of the configuration results in the current recording
being closed down and the new data being recorded in a separate
time frame from the "old" data. It is not possible to present the
data before reconfiguration and the data after reconfiguration as a
single entity.
For parameterization, some functions will not be available if no user is logged
in, or the user who is logged in does not have the access rights for these
functions.
Only the setting of individual current batch numbers is enabled in the factory
(default) setting.
The following functions may also be available, depending on the rights owned
by the user who is logged in.
- Fine adjustment of internal analog inputs,
- Setting of counter and integrators states, and
- Setting the date and time.
The Service functions will also not be available if no user is logged in, or the
user who is logged in does not possess access rights for these functions.
v Further information can be obtained from the Operating Manual
B 70.6580.0.