JUMO LOGOSCREEN Operating Instructions Manual page 31

Edit batch
Change
batch/plant
Start/stop
batch
H
Batch status
This function can be used to edit the batch text fields that are available
(configured for this purpose). When the function has been called up, the first
editable field in the screen will be activated.
h Press the control knob to start editing.
h Enter the text (Chapter 8 "Entering text and values").
h Rotate the control knob to select a new field or button, and activate it by
pressing the control knob.
Changeover between the individual batches/plants. A maximum of 3 plants
can be configured.
Use the parameter Device manager ! Configuration ! Batches/plants !
Plant X ! General ! Batch start to configure how a batch starts and
stops. The following are available:
- start/stop by a binary signal (control signal),
- start/stop by a bar code reader, and
- manual start/stop by control knob.
At least 5 seconds must elapse between the stop of a batch (batch
end) and the next start (batch start). A new batch can only be
started when this time has elapsed.
The batch report that is displayed is active.
The batch report that is displayed is not active.
3 Operator level (visualization)
31