Freezer Drawer Switch; Freezer Light Bulb; Freezer Light Housing - Viking RDDFF236 Service Manual

Service Diagnostics and procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.

Freezer Drawer Switch

To access the freezer drawer switch:
1. Open drawer.
2. Use a flat blade to depress light switch securing
tab.
3. Pull switch into freezer compartment and
disconnect wiring harness.
Wiring Harness
4. Repair or replace switch.
5. Reverse procedure to reinstall.
© 2012 Viking Preferred Service
WARNING

Freezer light Bulb

The unit uses a standard 40W, 120 VAC light bulb to
illuminate the freezer compartment.
To access the light bulb:
1. Open freezer drawer to replace light bulb.
Screwdriver
Blade

Freezer light housing

To access light housing:
1. Remove freezer light bulb (see Freezer Light
Bulb section above).
2. Insert a screwdriver blade into light housing to
disengage tabs.
Screwdriver
Blade
Light
Housing
38