Viking RDDFF236 Service Manual page 43

Service Diagnostics and procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.
Ice Maker (continued)
Just before the ejector completes the second
revolution, the ice maker turns the water valve ON
for approximately 7 seconds and refills the mold with
approximately 4 ounces of water and the freezing
cycle is ready to begin again.
1. To access the ice maker, open the freezer door,
remove bottom cover and the ice maker is
accessible.
2. To access module, motor, and support assembly,
loosen screws securing ice maker to bracket.
Screw
3. Lift ice maker from bottom to clear tabs.
Disconnect shutoff arm, disconnect wiring
harness and remove mold from bracket.
Tab
© 2012 Viking Preferred Service
Shutoff Arm
Wiring Harness
Tab
WARNING
4. Remove securing screws.
5. Lift the bracket up and toward the front of the
freezer to disengage the bracket tabs and
remove the bracket.
6. To access module, motor, and support
assembly, loosen screws in module access
ports, disconnect shutoff arm, disconnect
wiring harness and remove mold from support
assembly.
Module
Screw
43