Refrigerator Damper - Viking RDDFF236 Service Manual

Service Diagnostics and procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.

Refrigerator Damper:

To access the refrigerator damper:
1. Open doors and remove shelves.
2. Remove louvered cover off of damper control.
Louvered Cover
3. Remove screws holding housing to rear
wall and remove housing.
Screw
3. Disconnect wiring and remove damper.
Wiring Harness
© 2012 Viking Preferred Service
WARNING
4. Replace or repair as necessary.
5. Reverse procedure to reinstall.
Water Filter
The unit has a water filter system designed to filter
a flow rate of 0.78GPM and a maximum pressure of
120 PSI.
To access the water filter:
1. Open door(s), depress filter cover release, and
lower filter cover.
Filter Cover
2. Remove filter by turning counterclockwise.
Water Filter
35