Procom SSU320RHN-GB Owner's Manual page 13

MANUAL OPERATING
INSTRUCTIONS
Continued
5. Wait five (5) minutes to clear out
any gas. Then smell for gas, includ -
ing near the floor. If you smell gas,
STOP! Follow "B" in the safety infor -
mation on page 11. If you do not smell
gas, go to the next step.
6. Push in gas control slightly and turn
counterclockwise
and depress for five (5) seconds.
NOTE : The first time that the heater
is operated after connecting the gas
supply, the control knob should be
depressed for about thirty (30) sec -
onds. This will allow air to bleed from
the gas system.
7. With Control Knob pressed in, push
and release the ignitor button. This
will light the pilot. If needed, keep
pressing ignitor button until pilot
lights.
8. Keep Control Knob depressed for
ten (10) seconds after lighting pilot.
If pilot goes out, repeat steps 6, 7
and 8.
9. Turn counterclockwise
position. Do not operate between
locked positions.
Push in gas Control Knob slightly and
turn clockwise
Do not force.
When electric power is available and
electric operation is desired, turn clock -
wise
Then press down knob and rotate clock -
to PILOT/IGN wise
Do not operate between locked posi -
tions.
1. Open front door.
2. Follow steps 1 through 5 under
MANUAL OPERATING Lighting
Instructions .
3. With Control Knob in PILOT/IGN
position, strike match, and hold near
pilot. Press in Control Knob, pilot
should light.
4. Keep Control Knob pressed in for 30
seconds after lighting pilot. After 30
to "ON"
seconds, release Control Knob. Fol -
low step 9 under MANUAL OPERAT -
ING Lighting Instructions.
Figure 16 - Manual Control
TO TURN OFF GAS
TO APPLIANCE
to the OFF position.
to OFF position for one minute.
to ELECTRIC position.
MANUAL LIGHTING
PROCEDURE
(match light)
13