Jenn-Air SVE47500 Use And Care Manual page 13

The grill a ccessory consists oftwoblack g rill g rates,
a grill element, and two grill-rocks.
To Install Grill
1. Before installing grill components, be certain controls are OFF.
2. Place the two grill-rocks into an empty basin pan with their handles running parallel
to the front of the range. These grill-rocks must be used since they support the grill
element.
3. Position the grill element with the terminal plug towards the terminal receptacle.
This receptacle is located at the front of the left side and at the back of the right side
of the range. Slide the element towards the receptacle until the terminal plug is
completely engaged. The gdll element should now rest on the handles of the grill-
rocks.
4. Place the black grill grates on the top of the rangetop.
To Remove Grill
1. Remove grill components once they are cool. Be sure controls are OFF.
2. To remove grill element, pull away from receptacle until it is unplugged. (Note:
Lifting the element more than 2 inches above the rangetop surface while it is
engaged in the receptacle could damage the terminal plug.)
3. A storage tray, Model A350, is available for purchase and can be used for storing
the grill assembly.
Installing Other Grill Accessories
1. Remove the two black grill grates from the grill. Now you are ready to use the
optional gdll accessories.
2. Review the instructions for installing and using the accessories that are packaged
with the accessory.
Note: Accessory options are shown on page 50.
13