Jenn-Air SVE47500 Use And Care Manual page 11

Cooktop cartridges,
either conventional coil, halogen, radiant or solid element, can be
installed on either side of the range. (See page 51 for all available cartridges and model
numbers.)
To Install Cartridges
1. Jf the grill element, grill-rocks or grates are in place, remove before instaJlinga
cooktop cartridge. Clean porcelain basin pan of any grease accumulation. (See
page 17 for cleaning recommendations.)
2. To install any of the optional cooktop cartridges, be sure controls are turned OFF.
Positionthe cartridge terminal plug towards the terminal receptacle. This receptacle
is located at the front of the left side and at the back of the right side of the range.
3. Slide the cartridge towards the receptacle until the cartridge terminal plug is
completely engaged.
4. Lower the opposite end of the cartridge into the rangetop until it is flush with the
surface. Your range is now ready to use.
To Remove Cartridges
1. Controls must be OFF and the cartridge should be cool.
2. Lift up on the "tab" located on the cartridge until top of cartridge clears the opening
on the range by about 2 inches. Lifting the cartridge too high while still engaged in
the receptacle could damage the terminal plug.
3. To disengage terminal, hold cartridge by the sides and slide away from the terminal
receptacle. Lift out when fully unpiugged.
4. A storage tray, Model A350, is available and can be used for storing a cartridge,
5. Do not stack cartridges where they may fall or be damaged. Never store other
materials on top of the glass-ceramic cartridges since this could damage or scratch
the surface.
Canning should be done on the conventional coil cartridge only. Canning element
accessory, Model A145A, makes it possible to use large canners with the conventional
coil cartridge.
11