PL lens
The PL lens can be used by replacing the lens mount.
Replacing the lens mount
EF mount
Mount fixing ring
PL lens mount module
Fig. 2
1
Loosen the two mounting screws on the mount fixing ring. (Fig. 1)
f Use the 1.5 mm Allen wrench.
f The position of the mounting screw may not match with the illustration depending on the fixing condition of the mount.
2
Turn the mount fixing ring to remove the EF mount. (Fig. 1)
f If the fixing ring is stiff and does not turn, insert an Allen wrench into the tightening hole on the fixing ring and turn the fixing ring.
3
Attach the PL lens mount module. (Fig. 2)
f Align the positioning pin and the positioning hole. Also align the connector on the camera with the contact on the mount.
4
Turn the mount fixing ring to fix. (Fig. 3)
5
Fix the two mounting screws. (Fig. 1)
Chapter 3 Preparation — Mounting and adjusting the lens
Mounting
screw
Fig. 1
Positioning hole
Contact
Tightening hole
Mounting
screw
Tightening hole
Positioning pin
Connector
– 30 –
Mount fixing ring
Mounting screw
(Round hole, 2 locations)
Tightening hole
(4 mm hexagon hole, 2 locations)
Fig. 3