Table of Contents
Advertisement
a ae
ER
ee
ne
ee
=a
ee
a ee
cee
rm
ee
Eee
|
|
|
|
t
|
Lens Cap and Grip Belt
To protect the Lens surface, attach the Lens Cap. Adjust the length of the
Grip Belt to the size of your hand.
1
Attach the longer loop of the Lens Cap Cord to the Lens
Cap.
2
Attach the shorter loop to the grip belt.
3 Put.your hand through the Grip Belt and adjust the length.
The removed Lens Cap can be hooked onto the grip belt@. (When you are
not recording, be sure to keep the Lens Cap attached to the Lens for
protection.)
:
Prat tg
Page gp Fig Pig Pet Figd Pat Pat Mat
et ft
Pa
Pd
at
ae Pt Pt
ne Mg
ng Peet Pa
Pag Pay Pig Cag Mat Pet Pat Pt
Attaching the Shoulder Strap
We recommend that you attach the Shoulder Strap before going out of doors
to record so as to avoid dropping the Palmcorder.
1 Pass the tip of the Shoulder Strap through the Shoulder
Strap Holder on the Palmcorder and pull the Shoulder Strap.
2
Fold the tip of the Shoulder Strap, pass it through the
Shoulder Strap Length Adjuster, and pull it.
¢ Pull it out more than 1 inch (2 cm) @ from the Shoulder Strap Length
Adjuster so that it cannot slip off.
Pet
et et nt Ped iy Pint Rng ny Pag Pagt op Page Pap Pat Pat Ped nt ad Pe Pap fing Ong ty Png tg Fags Pag Piet Oe Pat Mae
' Inserting a Cassette
When power is supplied to the Palmcorder, the cassette can be taken out
without turning the Palmcorder on.
1 Slide the [OPEN/EJECT] Lever © to the right and pull down
to open the Cassette Compartment.
2
Insert a Cassette.
3
Close the Cassette Compartment and lock the Cassette
Compartment by pressing the [PUSH TO CLOSE] mark.
-4
Close the Lower Cassette Compartment Cover.
@ For other notes, see page 51.
§@ Accidental Erasure Prevention
Opening the accidental erasure prevention slider 4 | on the cassette (by
sliding it in the [SAVE] arrow direction} prevents recording. To enable
recording, close the accidental erasure protection slider (by sliding it in the
[REC} arrow direction.)
13
Advertisement
Table of Contents
