Preparing For Connection; For Wireless Module Aj-Wm30 - Panasonic VARICAM LT Operating Manual

Preparing for connection

For wireless module AJ-WM30

Connect the wireless module AJ-WM30 (optional) to the camera.
Fig. 1
1
Open the cover. (Fig. 1)
2
Remove the screw from the wireless module fixing part. (Fig. 2)
3
Attach the wireless module securely to the <USB HOST> terminal and secure with the screw that has been removed in step 2, and
close the door. (Fig. 3)
@ NOTE
t When removing the wireless module, pull it down straight.
t When connected with the wireless LAN, attach the wireless module securely and close the cover.
t When using a wireless module other than AJ-WM30, refer to "For wireless module other than AJ-WM30" (page 158).
Cautions when using wireless module
Read the operating manual of the wireless module thoroughly and understand it before using.
To prevent accidental operation, there are restrictions as follows:
f Supported standard: IEEE802.11g/n
IEEE802.11a and IEEE802.11b cannot be used.
f Communication frequency: 2412 MHz to 2462 MHz (1ch, 6ch, 11ch)
12ch and higher cannot be used.
r For use overseas
The following four types of products are available to comply with laws regarding radio wave of every region in the world. The products can be used only
in the country or region where they are supported.
f AJ-WM30MC
People's Republic of China
f AJ-WM30P
United States of America, Canada, Mexico, Argentina, Peru, Taiwan
f AJ-WM30E
EU member nations, EFTA member nations, Australia, New Zealand, Russia, Ukraine, Saudi Arabia, UAE, Kuwait, Oman, Egypt, Republic of South
Africa, Korea, Philippines, Malaysia, Singapore
f AJ-WM30
Japan
NOTE
@
t In France, using outdoors is prohibited.
Chapter 11 Network Connection — Preparing for connection
Wireless module fixing part
– 157 –
Fig. 2 Fig. 3