To Stop The Position Recall Operation Part-Way Through; Memory Recall Function (Driver’s Side Only); Registering Procedure - Lexus LX 570 2016 Service Manual

To stop the position recall operation part-way through

■
Perform any of the following:
Press the "SET" button.
●
Press button "1", "2" or "3".
●
Operate any of the seat adjustment switches (only cancels seat position recall).
●
Operate the tilt and telescopic steering control switch (only cancels steering wheel
●
position recall).
Operating the driving position memory after turning the engine switch off
■
Recorded seat positions can be activated up to 180 seconds after the driver' s door is
opened and another 60 seconds after it is closed again.
If the battery is disconnected
■
The memorized positions must be reset because the computer' s memory is erased when
the battery is disconnected.
Memory recall function (driver's side only)
Each electronic key can be registered to recall your preferred driving position.

Registering procedure

■
Record your driving position to button "1", "2" or "3" before performing the
following:
Carry only the key you want to register, and then close the driver' s door.
If 2 or more keys are in the vehicle, the driving position cannot be recorded
properly.
Check that the shift lever is in P.
1
Turn the engine switch to IGNITION ON mode.
2
Recall the driving position that you want to record.
3
While pressing the recalled but-
4
ton, press and hold the door lock
switch (either lock or unlock) until
the buzzer sounds.
If the button could not be registered,
the buzzer sounds continuously for
approximately 3 seconds.
LX570_OM_OM60N01U_(U)
3-3. Adjusting the seats
153
3