Function Button Setting - Sony Trimaster EL PVM-2541 Operating Instructions Manual

WFM/ALM (waveform monitor and audio
level meter) DISPLAY SETTING
USER CONFIG – WFM/ALM DISPLAY SETTING
W F M / A L M :
W F M / A L M S E L E C T :
P O S I T I O N :
Submenu Setting
WFM/ALM Selects ON to display the WFM/ALM
display and OFF not to display.
Note
When the WFM/ALM display is
enabled, the marker display is not
available.
WFM/ALM • WFM: A waveform monitor is
SELECT
• ALM: An audio level meter is
When WFM is selected, the waveform
and audio level are displayed. When
ALM is selected, the audio level is
displayed in eight channels.
The audio levels of WFM or ALM are
displayed when SDI signal is input.
Select the displayed audio level channels
in SDI AUDIO SETTING.
The indications of the waveform (only
when WFM is selected) and audio level
signify as illustrated below, although the
percentage of the waveform, units and
values of the scale for the audio level do
not appear on the display.
When WFM is selected
109%
100%
75%
50%
25%
0%
-4%
Channel number
(The channel number which is selected in
SDI AUDIO SETTING is displayed.)
64
Adjustment Using the Menus
xx
xxx
x
displayed.
displayed.
Waveform Audio level
(dB)
1 2
Submenu
When ALM is selected
Audio level
1 2 3 4 5 6 7 8
Channel number
(Displayed in eight channels, including the channel
which is selected in SDI AUDIO SETTING.)
POSITION

FUNCTION BUTTON SETTING

USER CONFIG – FUNCTION BUTTON SETTING
F 1 B U T T O N :
F 2 B U T T O N :
F 3 B U T T O N :
F 4 B U T T O N :
F 5 B U T T O N :
F 6 B U T T O N :
F 7 B U T T O N :
Submenu
F1 BUTTON to F7
OVER
BUTTON
0
-10
-20
-30
-60
Setting
(dB)
OVER
0
-10
-20
-30
-60
Sets the position of the WFM/ALM
display. You can select from among 1 to
4.
• 1: Bottom left
• 2: Bottom right
• 3: Top right
• 4: Top left
xxxx
xxxx
xxxx
xxxx
xxxx
xxxx
xxxx
Setting
Assigns the function to the function
buttons of the front panel and turns the
function on or off.
You can assign the function from among
SCAN, ASPECT, BLUE ONLY,
MONO, MARKER, I/P MODE and
WFM/ALM.
Factory setting
• F1 button: BRIGHTNESS
• F2 button: CONTRAST
• F3 button: CHROMA
• F4 button: SCAN
• F5 button: H/V DELAY
• F6 button: VOLUME
• F7 button: I/P MODE