Programming Special Functions - Miele G 7782 CD Operating Instructions Manual

Programming special functions

The following special functions can be
programmed where appropriate:
1. Extending the water inlet from 60
seconds to 120 seconds with level
control
If the inlet water pressure is lower than
35 psi (2.5 bar), too little water will flow
into the wash cabinet. By selecting the
extended water inlet, more water will
flow into the wash cabinet if there is low
water pressure (between 15 and 35 psi
[1.0 and 2.5 bar]).
^ Turn off the washer/disinfector.
^ Press DRAIN and DRYING touch
pads at the same time, while turning
on the machine. "Pxx" appears in the
display field.
^ Press DISINFECTION 93°C -10 MIN
touch pad.
"10" or "11" will appear in the display.
10 = 60 seconds water intake
11 = 120 seconds water intake
with level control
^ Press DRYING touch pad to change
the display to "11".
^ Press START touch pad. "SP" ap-
pears in the display field.
^ Press START again. The change is
now stored and the display field
clears.
34
2. Deactivating of neutralizer dis-
pensing
The G 7782 CD is programmed from
the factory to dispense neutralizer dur-
ing the first interim rinse. It is strongly
recommended to use this option to
avoid discoloration or corrosion of in-
struments. However, dispensing of neu-
tralizer might not be necessary if a pH
neutral detergent is being used.
To deactivate the neutralizer setting
perform the following.
^ Turn off the washer/disinfector.
^ Press DRAIN and DRYING touch
pads at the same time, while turning
on the machine. "Pxx" appears in the
display field.
^ Press WASH 93°C touch pad.
"20" or "21" will appear in the display
field.
20 = without interim rinse I
21 = with neutralizing agent dis-
pensed in interim rinse I
^ Press DRYING touch pad to change
from 21 to 20 or vice versa.
^ Press START touch pad. "SP" ap-
pears in the display field.
Press START again. The change is now
stored and the display field clears.