Position the salt container as
follows:
1. Remove the lower basket from the
machine.
2. Unscrew the plastic cap in the base
of the wash cabinet.
3. Place the salt container on the reacti-
vation socket and screw firmly into
place.
Reactivating the water softener
4. Close the door.
5. Turn on the washer/disinfector.
6. Press the REACTIVATION touch pad.
7. Press the START touch pad. The re-
activation program proceeds auto-
matically.
8. When the REACTIVATION light at the
left hand side of the control panel
and the START indicator light have
gone out, turn off the washer/
disinfector.
9. Remove salt container slowly, allow-
ing pressure to be released. Do not
open by force, If you cannot unscrew
it by hand, contact the Miele Techni-
cal Service Department.
10. Screw the plastic lid back on the
socket.
11. Reposition the lower basket.
12. Rinse the salt container and filter
insert thoroughly.
IMPORTANT: If, after REACTIVATION
cycle, salt is still found in the salt con-
tainer, water pressure may be fluctuat-
ing or is below 35 psi (2.5 bar). If this is
the case, run the REACTIVATION cycle
again to wash all water softener from
the salt container.
41