Unloading The Washer/Disinfector - Miele G 7782 CD Operating Instructions Manual

Washer/disinfector
Table of Contents

Advertisement

1. When the cycle is finished, the indi-
cator light next to the START touch
pad will go out.
2. If one of the DISINFECTION cycles
was chosen, check the DISIN-
FECTED indicator light. If it is not lit,
the load is not disinfected! In this
case, please call for technical assis-
tance.
3. Check, if any warning lights (left
hand side of the control panel) are
on, or if the display field shows two
dashes. If so, refer to the section
"Troubleshooting", or call for techni-
cal assistance.
WARNING - BURN HAZARD: Allow
accessories to cool to room temper-
ature before unloading. Any water
which may have collected in incor-
rectly loaded items will be very hot
and should be emptied into wash
cabinet.

Unloading the washer/disinfector

4. Open the door partially (about
4 inches [10 cm]). Let the load cool
down for about 10-15 minutes. Dur-
ing this time the load will usually dry.
If drying cycle is selected, it is still
recommended to open the door par-
tially to let instruments cool.
5. Safely unload the washer/disinfector.
WARNING - FALL HAZARD: To prevent
falls, keep floors dry by immediately
wiping up any spilled liquids in
washer/disinfector loading and unload-
ing area.
33

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents