FSPF configuration task list
Tasks at a glance
Change FSPF parameters for a VSAN in VSAN view:
•
(Required.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
(Optional.) Change FSPF parameters for an interface in E_Port interface view:
•
Configuring the FSPF cost
•
Configuring the hello interval
•
Configuring the dead interval
•
Configuring the LSR retransmission interval for interfaces
•
Disabling FSPF for an interface
(Optional.) Configuring FSPF GR in system view:
•
Configuring the GR Restarter
•
Configuring the GR Helper
Enabling FSPF
FSPF-related functions can work in a VSAN only after you enable FSPF for the VSAN.
To enable FSPF:
Step
1.
Enter system view.
2.
Enter VSAN view.
3.
Enable FSPF for the VSAN.
Configuring the shortest SPF calculation interval
When the LSDB changes, SPF calculations occur and consume CPU resources. To prevent frequent SPF
calculations from overconsuming the CPU, you can configure the shortest SPF calculation interval.
The shortest SPF calculation interval defines the minimum interval between two consecutive SPF
calculations. A smaller value means that FSPF responds faster to fabric changes by recalculating routes
in a VSAN, but it requires more CPU resources.
To configure the shortest SPF calculation interval:
Step
1.
Enter system view.
2.
Enter VSAN view.
3.
Configure the shortest SPF
calculation interval.
Enabling FSPF
Configuring the shortest SPF calculation interval
Configuring the minimum LSR receiving interval
Configuring the minimum LSR refresh interval
Command
system-view
vsan vsan-id
fspf enable
Command
system-view
vsan vsan-id
fspf spf-hold-time value
Remarks
N/A
N/A
By default, FSPF is enabled after a VSAN is
created.
Remarks
N/A
N/A
The default setting is 0 second.
42