Configuration Procedure - HP 5920 series Configuration Manual
Hide thumbs
Also See for 5920 series:
- Command reference manual (607 pages) ,
- Configuration manual (424 pages) ,
- Fc and fcoe configuration manual (257 pages)
Table of Contents
Advertisement
Figure 19 Network diagram
Configuration procedure
Configure Switch A:
1.
# Configure Switch A to operate in FCF mode and bind interface VFC 100 to interface
Ten-GigabitEthernet 1/0/1.
<SwitchA> system-view
[SwitchA] fcoe-mode fcf
[SwitchA] interface Vfc 100
[SwitchA-Vfc100] bind interface Ten-GigabitEthernet1/0/1
[SwitchA-Vfc100] fc mode e
[SwitchA-Vfc100] port trunk vsan 2
[SwitchA-Vfc100] quit
# Enable the fabric configuration function.
[SwitchA] vsan 2
[SwitchA-vsan2] domain configure enable
# Configure the domain ID as 1.
[SwitchA-vsan2] domain-id 1 static
Non-disruptive reconfiguration or isolating the switch may be performed. Continu
e? [Y/N]:y
[SwitchA-vsan2] quit
# Enable FCoE for VLAN 10 and bind VLAN 10 to VSAN 2.
[SwitchA] vlan 10
[SwitchA-vlan10] fcoe enable vsan 2
[SwitchA-vlan10] quit
# Enable FSPF globally.
[SwitchA-vsan2] fspf enable
[SwitchA-vsan2] quit
# Enable FSPF for interface VFC 100.
[SwitchA] interface Vfc 100
[[SwitchA-Vfc100] port trunk vsan 2
[SwitchA-Vfc100] undo fspf silent vsan 2
Configure Switch B:
2.
# Configure Switch B to operate in FCF mode and bind interface VFC 100 to interface
Ten-GigabitEthernet 1/0/1.
<SwitchB> system-view
[SwitchB] fcoe-mode fcf
[SwitchA] interface Vfc 100
[SwitchA-Vfc100] bind interface Ten-GigabitEthernet1/0/1
[SwitchA-Vfc100] fc mode e
[SwitchA-Vfc100] port trunk vsan 2
[SwitchA-Vfc100] quit
50
Advertisement
Table of Contents
